![Hotchkis 1416 Installation Download Page 2](http://html.mh-extra.com/html/hotchkis/1416/1416_installation_2165921002.webp)
05-Current Ford Mustang
Hotchkis Performance LLC.
2
UNDER BODY BRACE INSTALLATION
1.
Safely raise the vehicle and unbolt the stock center bar.
NOTE: This is the only stock part that needs to be removed before installation. If it is a later
model Mustang where there studs, the nuts will be used in the installation. If there are holes
instead of studs, use the supplied hardware.
2.
Install the new under brace by hand tightening the four (4) nuts/bolts. If only
holes are there use supplied 12mm X 30mm bolts, nylock nuts, and washers.
NOTE: Do not tighten these bolts yet. Just start the bolts in the holes so that the brace is
supported. This will make it easier to bolt up the rear section.