5.
Ensure that all gas connections are leak proof and that there are no gas leaks.
NOTE:
UNBURNT GAS CAN BE TOXIC TO PLANTS.
6.
DO NOT
look for leaks with a lighted taper! Check all suspect connections with a
soap solution and cure as necessary. OBSERVE THE SAFETY CODE.
(B)
IGNITION
1.
Depress and hold the control knob (Fig 1). Press the piezo ignition button
repeatedly (Fig 2) until pilot burner ignites.
2.
After the pilot burner has ignited, hold the control knob for a few seconds until
the thermocouple has been sufficiently heated by the pilot flame to generate
sufficient current to keep the solenoid valve energised. Then release the knob.
NOTE:
If the generator is newly installed, or has not been used for a long period,
it will be necessary to purge the air from the pilot gas system before attempting to
ignite the burner. This is achieved by depressing the control knob and holding for
approximately 30 seconds or more until the gas comes through.
4.
Once the pilot burner is alight, release the control knob and the main flame will
ignite
FIG
1
FIG
2
(C)
EXTINGUISHING THE APPLIANCE
3
