-11-
STEP 5
Take off the cover by removing (4) four #10 X 1/2
screws. NOTE: Retain the (4) four #10 X 1/2 screws, they
are required for the following steps.
STEP 6
Loop the wire around the top center bolt of the slide
plate. Run the wire up and through the loop clamp,
then out of the hole found at the top right side of the
cover as shown. NOTE: Check the assembly to ensure
that everything moves smoothly and there is no binding.
STEP 7
Reattach the cover using the previously removed (4)
four #10 X 1/2 screws.
STEP 8
Remove the nuts and cover of the adjustable
compression sleeve and route the wire through as
shown. Replace the nuts and cover, and hand tighten.
Do not over tighten.
STEP 9
Connect the wire to the servo arm by looping the wire
around the 1/4-20 X 3/4 bolt as shown. After the wire
loop is in position reduce the loop size so that it is smaller
than the washer. This will prevent it from sliding off once
the unit is in operation.
STEP 10
Attach the limit switch and thermodisc to the back of
the unit as shown using (3) three #10 X 1/2 screws. NOTE:
The limit switch must be installed above the thermodisc.
