1
2
3
I
O
1
2
3
I
O
II. VEHICLE OPERATION
*
If your vehicle doesn’t move when you use the trans-
mitter there’s a good chance your vehicle’s battery is
ready for a recharge.
III. B ATTERY INSTALLATION
Note: Your vehicle can be used with a Tyco
®
R /C 9.6 V NiC d
battery pack or 6 AA alkaline batteries.
R eq uires a Tyco
®
R /C 9.6 V NiC d battery pack or 6 AA
alkaline batteries for vehicle and 2 AA alkaline batteries
for transmitter.
*
Though your vehicle can run on both 9.6 V or
6 x AA batteries it will run up to 30% faster when
using a 9.6 V rechargeable battery.
Vehicle
9 .6 V NiCd battery pack
1. U se a screwdriver (not included) to unscrew the battery
cover.
2. U nscrew and remove the AA battery adapter. Store in a
safe place for later usage.
3. Insert the 9.6 V NiC d battery pack (not included), with
polarity (+ /-) as shown inside the battery
compartment .
4 . Plug the wire connector into the battery compartment
as shown.
5. R eplace the battery cover.
6 AA alk aline batteries
1. U se a screwdriver (not included) to unscrew the battery
cover.
2. M ake sure the AA battery adapter is firmly in place. If
it’s not, position the adapter in the box and fasten it with
the screw.
3. Insert the 6 AA batteries (not included), with polarity
(+ /-) as shown inside the battery compartment .
4 . R eplace the battery cover.
Transmitter
1. R emove the battery cover as shown.
2. Install 2 AA batteries (not included), with polarity (+ /-) as
shown inside the battery compartment.
3. R eplace the battery cover.
*
If the transmitter’s LED indicator does not light when
the transmitter is switched ON, it’s time to replace the
transmitter batteries. Simply install fresh batteries as
described above.
RIG HT
FORW ARD
REVERSE
LEFT
RIG HT
9 .6 V d.c. NiCd,
1 x 8 ”AA”,
7 0 0 mAh
6 x AA
