Hostess HM500A, Instructions For Use Manual, Page: 4 / 8

4
The Milk Frother is supplied with four blenders, marked ’foam’. These will produce a frothy drink. The two
stirrers marked ’mix’ can be used to produce a hot drink that is not frothy.
To change the blender firmly pull the blender upwards, at an angle to the base, to remove it from the spigot in
the base of the pot. Position the required blender onto the spigot and then press firmly downwards until it
clicks into place. Ensure that the blender rotates freely on the spigot.
The spare blender and stirrer are located on the underside of the base unit.
CLEANING & MAINTENANCE
Before cleaning the base unit after use, wait for the appliance to cool down.
When cleaning the pot, use a sponge or a soft brush together with normal washing up liquid.
Warning : Be aware of the spigot in the base of the pot when cleaning by hand.
Do not use any solvents or abrasive detergents. Sharp or hard instruments or steel wool is strictly forbidden.
When cleaning the base unit, disconnect from the power supply and just use a damp cloth. Take care not to
wet any electrical parts. Do not wash the base unit in a dishwasher.
Fig.14 Remove the blender from the bottom of the pot and clean thoroughly.
Fig.15 The pots can be cleaned with warm soapy water or washed in a dishwasher.
Fig.16 Do NOT pour water into the base unit.
Fig.17 The base unit must NOT be immersed in water.
Fig.18 The spare blender and stirrer are stored under the base unit.
PROBLEM SOLVING
Fig.19 When the light is flashing this indicates a problem with the thermostat of
the appliance. Please switch off the electricity supply and inform the service
department.