Hospira LifeCare XL Series, Technical & Service Manual

Page: 93 / 278

SECTION 7 REPLACEABLE PARTS AND REPAIRS
430-00587-008 (Rev. 2/05) 7 - 14 Plum XL Series

Note: (XLM with DataPort) When joining the front and rear enclosures, do not
pinch the DataPort/MCU cable between the two enclosures.
12. Connect the infusion system to AC (mains) power.
To verify successful control knob, knob detent, washer, and snap retainer replacement,
perform the PVT in
Section 5.2 .
7.2.7.4
FRONT PANEL LABEL REPLACEMENT
Recommended tools and materials for this procedure are an X-acto knife, long needle nose
pliers, and mild solvent.
The replacement part for this procedure is:
Label, Front Panel
To replace the front panel label, refer to Figure 7-4 , then proceed as follows:
1. Turn the control knob to OFF/CHARGE.
2. Disconnect the infusion system from AC (mains) power.
3. Using an X-acto knife, remove the front panel label from the front panel enclosure.
4. Using a mild solvent, remove adhesive residue from the front panel assembly recess.
5. Remove the adhesive backing from the replacement front panel label and press the
label into place on the front enclosure assembly.
Replacement of the front panel label is a routine maintenance procedure and no
verification procedure is normally required. However, if the infusion system may have been
damaged during this procedure, perform the PVT in
Section 5.2 .
7.2.8
REAR ENCLOSURE ASSEMBLY COMPONENT
REPLACEMENT
Rear enclosure assembly component replacement includes the replacement of the
following:
❏
Fuses
❏
Power supply PWA
❏
Velcro retainer strap
❏
AC (mains) power cord, and strain relief bushing
❏
AC (mains) power cord (International)
❏
AC receptacle, EMI shield, and equipotential post
❏
LifeCare AC receptacle, bracket, gasket, seal, and equipotential post
❏
DataPort/MCU cable assembly
❏
LifeCare DataPort/MCU cable assembly
❏
Pole clamp extrusion, knob, backing plate, and adhesive-backed insulator
❏
Pole clamp shaft/knob assembly and the pole clamp shaft tip
❏
Buzzer PWA and MCU/buzzer cable