14
Fig. 6
Control Box
Insulation
Bin Control
Cover
Bin
Control
Insulation
Bin
Control
Cover
Bin Control Extension Bracket
and 2 Thumbscrews from
Accessory Bag
Bin Control
Fig. 7
Notch
Slot
2. Bin Control Installation
NOTICE
Before operating the icemaker, the bin control assembly must be installed correctly.
Failure to properly install the bin control assembly could result in ice backup and
unit damage.
Follow the instructions below for bin control assembly installation.
1) Remove the front panel, right side panel, and top panel.
2) Loosen the screws securing the control box, then lift the control box off and hang it from
the base. See Fig. 6.
3) Remove the insulation.
4) Remove the thumbscrews securing the bin control cover. Remove the bin control cover
and bin control.
5) Remove the bin control from the bin control cover.
6) Remove the bin control extension bracket and 2 thumbscrews from the accessory bag.
Route the bin control cable around one of the notches on either side of the extension
bracket, then secure the bin control to the bin control extension bracket using the
2 thumbscrews. See Fig. 7.
Note: All thumbscrews used in the bin control assembly are the same size.
7) Using 2 existing thumbscrews, attach the bin control extension bracket to the bin control
cover.
8) Route the bin control cable through the slot in the bin control cover, then place the bin
control assembly into position and secure with 2 existing thumbscrews.
9) Replace the insulation in its proper position.
10) Secure the control box in its proper position.
