20
8) Move the Control Switch, on the Control Box, to the “WASH” position
9) Replace the Insulation Panel and the Front Panel in their correct positions.
10) Turn on the power supply, and start the washing process.
11) Turn off the power supply after 30 minutes.
12) Remove the Front Panel.
13) Remove the back end of the Pump Tubing. Drain the Water Tank. Replace the Pump
Tubing in its correct position.
14) Move the Control Switch to the “ICE” position.
15) Close the Cleaning Valve. See Fig 10.
16) Replace the Front Panel in its correct position.
17) Turn on the power supply to fill the Water Tank with water.
18) Turn off the power supply after 3 minutes.
19) Remove the Front Panel, and fully open the Cleaning Valve.
20) Move the Control Switch to the “WASH” position.
21) Replace the Front Panel in its correct position.
22) Turn on the power supply to rinse off the cleaning solution.
23) Turn off the power supply after 5 minutes.
24) Remove the Front Panel.
25) Remove one end of the Pump Tubing. Drain the Water Tank. Replace the Pump Tubing
in its correct position.
26) Repeat the above steps 14) through 25) three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to Step 10) in “[b] SANITIZING PROCEDURE.”
