37
7) Install the new water valve, and replace the removed parts in the reverse order of which
they were removed. Make sure the washers are in place in the fitting nuts.
8) Open the water supply line shut-off valve.
9) Turn on the power supply.
10) Check for leaks.
11) Replace the panels in their correct positions.
L. Removal and Replacement of Wash Valve
1) Turn off the power supply.
2) Close the water supply line shut-off valve.
3) Remove the top panel and the insulation panel.
4) Remove the screws securing the valve to the bracket.
5) Disconnect the hoses and the terminals.
6) Note the orientation of the rubber grommet, then remove the rubber grommet and the
valve.
7) Put the rubber grommet on the new valve and then install the valve.
8) Replace the removed parts in the reverse order of which they were removed.
9) Open the water supply line shut-off valve.
10) Turn on the power supply.
11) Check for leaks.
12) Replace the panels in their correct positions.
M. Removal and Replacement of Pump Motor
1) Turn off the power supply.
2) Remove the top panel and the insulation panel.
3) Disconnect the pump suction and discharge hoses.
4) Remove the water tank by pressing
down on the snaps on Bracket (L) and
Bracket (R) and pulling the tank towards
you.
5) Remove the drain pan assembly from
Bracket (R) by pulling it towards you. It is
snapped in place.
6) Disconnect the ground wire from the frame
and disconnect the pump wiring at the
connector.
7) Push up on the plastic tab securing the
water pump and slide the pump forward to
remove it.
Bracket (L)
Bracket (R)
Water
Tank
Bracket (R)
Drain Pan
Drain Tube
Frame/Pipe
