ENGLISH
2
3) Fix the two rear shakeproof fittings to the
floor.
4) Mount the refrigerator/freezer on the fixed
shakeproof fittings.
5) Fix the front shakeproof fittings.
* Locate and orient the fittings to optimize the
function of the anchor bolts.
* The shakeproof legs will raise the height by
about 5 mm.
4. SET UP
IMPORTANT
1. Do not tilt the unit more than 45° when
mounting the casters or legs.
2. Carry the unit by holding its bottom.
3. Remove all stuff inside the cabinet before
moving the unit.
1) Cut the vinyl shipping tape and remove the
carton.
2) Take out the accessory shelves, shelf clips.
Attach the four shelf clips horizontally to the shelf
posts. Place the shelf on the shelf clips.
3) Bfore operating the unit, remove all shipping
carton, packing, tape(s) and protective plastic
film on the exterior. Be careful not to damage the
exterior panels.
* Avoid a site where dripping is not allowed.
Especially, a side-by-side or back-to-back
installation (possibly with other manufacturer’s unit)
may cause condensation between the two units,
resulting in dripping onto the floor.
* Do not expose the unit to direct sunlight or higher
temperatures.
* Allow at least 100 cm clearance at the front of the
unit for smooth door operation. Also allow at least
30 cm clearance from the ceiling to the top of the
unit for proper air circulation.
* Protect the unit from tipping over by fixing the four
legs with the following tip-resistant kit (optional):
[Tip-resistant kit]
Adjustable leg (4Y2042-01, optional)
4
Shakeproof leg (454440-01, optional)
4
Shakeproof fitting (454441-01, optional)
4
Anchor bolt M10 (not provided)
4
[Installation example]
1) Replace the casters/adjustable legs with the
optional adjustable legs.
2) Replace the adjustable ends of the legs with
the shakeproof legs.
Fig. 2
MIN: 30cm
MIN: 100cm
Fig. 3
Bottom View
Side View
Shakeproof
Fitting
Shakeproof leg