ENGLISH
10
Fig. 7
Shelf Clip
Shelf Post
Push
Hook
CAUTION
Attach the shelf clips properly to make the shelf
level.
* To lay the shelf at the bottom of the cabinet, attach
two shelf holders each to the left and right frames
and one to the center frame as shown below.
2) Take out the accessory legs.
3) Tilt the unit backward to mount the front legs (work
in pair).
Fig. 5
Fig. 4
Carton (Base)
Carton
Shipping Band
CAUTION
The height of the adjustable legs must be within
9 - 12 cm (or 15 - 18 cm for some models).
If extended too much, the legs may become
weak or the adjusters can come off, causing
unexpected injuries.
5. SHELF, SHELF CLIP AND SHELF HOLDER
* The shelf is adjustable in 2.5 cm increments. Adjust
the shelf clips according to the height of stored
items.
* To attach the shelf clip, insert the upper tab into
an adjust hole in the shelf post to hook the shelf
clip, and push the lower tab into another adjust
hole until it locks in place. To detach the shelf clip,
reverse the above procedure.
4. SET UP
IMPORTANT
1. Do not tilt the unit more than 45° when
mounting the legs.
2. Carry the unit by holding its bottom.
1) Cut the shipping band and remove the carton.
4) Mount the rear legs in the same way.
5) Before operating the unit, remove all shipping
carton, packing, tape(s) and protective plastic film
on the exterior, interior and top panel. Be careful
not to damage the exterior panels.
6) Position the unit in a selected site.
7) Clean the interior with a soft cloth soaked in cold
or warm water containing the proper amount of
neutral cleaner and wrung dry.
8) Level the refrigerator/freezer in both the left-to-
right and the front-to-rear directions. To adjust
the height of the unit, turn the adjusters of the
adjustable legs.
Fig. 6
Adjustable Leg
Adjuster
Leg Height
Longer Shorter
Fig. 3
Air Outlet
Air Inlet
Min. 50cm
