ENGLISH
3
I. INSTALLATION INSTRUCTIONS
1. UNPACKING
WARNING
Children should not be allowed in reach of
the packaging elements (plastic bags and
expanded polystyrene) as they are potential
sources of danger.
CAUTION
Remove shipping carton, tape(s) and packing.
If packing material is left in the ice dispenser,
it will not work properly.
1) After removing the packaging, make sure that
the ice dispenser is in good condition. If in doubt,
please do not use the equipment but apply to
professionally qualified personnel.
2) Remove shipping tapes holding the package of
accessories, and check the contents:
a) Installation Kit
Inlet Hose
1
Outlet Hose
1
Rc1/2-G3/4 Nipple
1
b) Brace
1
c) Machine Screw
2
d) Tapping Screw
2
3) Remove tapes holding the power cord.
Normal operating water temperature should
be within 5°C to 35°C. Operation of the ice
dispenser, for extended periods, outside
of these normal temperature ranges may
affect production capacity.
2. The ice dispenser should not be located
next to ovens, grills or other high heat
producing equipment.
3. The location should provide a firm and level
foundation for the equipment at normal
counter top height.
4. Allow 15 cm clearance at rear and top and
5 cm at sides for proper air circulation and
ease of maintenance and/or service should
they be required.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. Do not place anything on top of the ice
dispenser to obstruct the ventilation louver.
7. This ice dispenser will not work at
subfreezing temperatures. To prevent
damage to the water supply line, drain
the ice dispenser when air temperature is
below zero (see “II. 2. PREPARING THE
ICE DISPENSER FOR LONG STORAGE”).
3. INSTALLATION
* Incorrect installation can cause harm to people,
animals or things, for which the manufacturer
cannot be held responsible.
* Secure the ice dispenser to the counter table by
using the brace, machine screws and tapping
screws (accessory). See Fig. 2.
Fig. 1
Front Panel
Push Button
Spout
Grille
Air Filter
Power Cord
2. LOCATION
IMPORTANT
1. This ice dispenser is not intended for
outdoor use. Normal operating ambient
temperature should be within 5°C to 40°C.
Fig. 2
Counter Table
Machine Screw
Brace
Tapping Screw
