©2016 HO
S
C
H
2
1
2
3
2
6a. Install the assembly carrier (belt width 600 - 1,050 mm)
1. Slide the assembly carrier through the installation
hatches.
2. Slide the assembly carrier tube into the installed mount-
ing.
3. Push the second mounting (tensioning side) over the
assembly carrier and bolt it to the conveyor frame.
6b. Install the assembly carrier (belt width 1,200 - 2,400 mm)
1. Introduce the assembly carrier midsection (
1
) into the
chute.
2. Slide the assembly carrier end-sections (
2
) through the
mountings and insert them fully into the carrier midsec-
tion. Ensure that the pins welded inside the midsection
align with the notches on the end sections.
3. Tighten the clamp screws (
3
).
Note: Alternatively, if there is enough space avail-
able, you may slide the assembly carrier into the
chute from outside directly after completing installa-
tion steps 4a and 6a.
Installation and Operation Manual Type HD-PU-L
Page 9 of 14
The contents of this document may be subject to technical modifications
INSTALLATION (Continued)