-
7
-
The Leader of Ultrasonic Misting
Technology
3.2 Connecting the Unit
A. Overflow and Drain Connections
Connect the tubing as shown in the picture. Be sure to insert the rubber rings
(washers). Connect supplied tubing and run to the nearest drain, this U shaped piping
assembly connection is for draining the unit to clean and to provide over flow outlet in
case of float device malfunction.
B. Water Input
Thread the supplied ½ threaded to ¼ push fitting adapter to the inlet port on the side
of the unit. Be sure to use the supplied rubber washer and be careful not to over tighten
and damage the unit.
You may alter your layout / connections / fittings to customize to your needs. The
only required connection above is the water supply in and a shut off fitting on the drain
outlet. The optional filter shown in the above diagram is recommended as it will remove
excess minerals in the water. Without any pre-filter you may get calcium and other
mineral deposits built up in the unit and the surrounding area. The most common
(optional)
to water supply (saddle valve)
to drain
