20
Depth Setting
• Remove the hitch pins and slide out the shoe heal
pins as shown.
• Lift the upper shoe assembly and remove the four
carriage bolts and lock nuts,
• Remove the upper shoe mount from the assembly,
• Locate the assembly in one of the three depth location
holes on the mount.
• Replace and tighten securely the carriage bolts and
lock nuts and replace the entire assembly on the lower
shoe assembly
• Replace the shoe heal pins and secure with the hitch
pins.
Hitch Pin
Lower Shoe Assembly
Shoe Heal Pin
Upper Shoe Mount
Upper Shoe Assembly
3 Position Depth
!
WARNING
Operational Hazard
When making adjustments involving remov-
al of hardware, ensure when the hardware is
replaced it is securely fastened and torqued
according to the torque chart at the back of
this manual.
In addition to re-positioning along the rail the universal
header pad features three height settings with a forward /
back tilt and three depth settings.
Height Setting
• Remove the hitch pins and slide out the shoe heal
pins.
• Select and move the upper shoe assembly to one of
the two remaining set of holes.
• Replace the shoe heal pins and secure with the hitch
pins.
Tilt Setting
• When you have selected a height, remove the outside
hitch pin and slide out the shoe heal pin as shown.
• Pivot the upper shoe assembly so it lines up with pin
hole.
• Replace the shoe heal pin and secure with the hitch
pin.
Pad Height, Tilt & Depth Settings
Forward Tilt
Back Tilt
Shoe Heal Pin
Outside Shoe
Heal Pin
Forward Tilt
Back Tilt
Shoe Heal Pin
Outside Shoe
Heal Pin
Forward Tilt Settings
3 Height Settings
!
WARNING
Operational Hazard
Ensure locking & heal pins are secured with
hitch pins. If a hitch pin is lost or damaged,
replace only with the same style hitch pin.
There are two 50mm (2.0”) wide, sliding ratchet straps
included with the header wagon. They are fully re-
positionable anywhere along the bottom rail. Once in your
selected position, follow the points below to release or
tighten the strap.
Release the strap from the ratchet:
• Pull up on the centre latch, and move the handle up
out of the lock position, to the upper stop
• Pull up on the centre latch, and move the handle
past the stop, and the ratchet will release.
• Pull out as much strap as you need.
To tighten the strap:
•
Attach the end of the strap to a secure location
• Pull up on the centre latch and pull the handle
down to engage the ratchet, and begin ratcheting,
continue to pull the handle up and down.
• When the strap is tight, pull up on the centre latch,
lower the handle into the lock position.
•
Ensure the handle is locked before proceeding
with transport.
