horsch Leeb 5.280 VL, Operating Instructions Manual

Page: 245 / 308

Flushing in liquid preparations
during filling
Water systems Basic Pro and water sys -
tem CCS Pro
1. Enter the desired container capacity in the
terminal.
2. Connect the suction hose to the filling port
and open the filling valve.
Filling port
3. Start filling via terminal.
4. Switch on the illuviation valve on the terminal.
5. Open the lid on the illuviation valve.
6. Fill the preparation quantity calculated and
measured for filling the tank into the illuvia -
tion valve.
7. Turn the switch-over ball valve (5) to the po-
sition for sucking-off. Have the content com -
pletely sucked off from the illuviation valve.
8. Close the switch-over ball valve (5) again.
The process may need to be repeated if the
required preparation could not be filled in
during a single process.
9. Pre-clean the illuviation valve with the rinsing
nozzles (4).
10. Open the switch-over ball valve (5) and have
the contents sucked off.
11. Close the switch-over ball valve (5) again.
12.
Switch off the illuviation valve on the ter -
minal.
13. Top up the water shortfall.
14. Adjust the desired agitator power.
5
1
2
3
4
During the filling process the water sucked in
through the suction hose is present at the illu-
viation valve.
Once the desired tank content is reached, the
suction valve will automatically switch over to
the spraying mixture container. Solution is then
present at the illuviation valve.
Use the washing gun to remove any residues
from the illuviation valve. Pull lever (2) and op-
erate the gun.
Make sure that no undesired point-type entries
of preparation are generated!
240 241