PAGE
3
F/A-18 HORNET
ASSEMBLY INSTRUCTIONS
1
CUT OUT ALL
SHAPES
Cut out all shapes, making sure to
cut slits where solid internal lines
are shown.
4
CURL THE NOSE
Creasing at each dotted line, curl
the nose over the opposite side and
tuck it underneath.
7
CREATING THE
NOSE TIP
Fold the nose tip inwards at each
dotted line.
2
MAKING THE NOSE
SECTION
Select this part of the model.
5
SECURE NOSE IN
PLACE
Turn piece over. Push tab into
matching slot to secure the nose
in place.
8
PUSH TABS INTO
MATCHING SLOTS
Tuck the two sides in and fold the
long fl ap over, pushing the tabs into
their matching slots to secure.
3
FOLDING
INWARDS
Turn the piece over. Fold up the two
sides as shown and tightly fold over
the outer most crease on each side.
6
FOLD SMALL END
FLAP INWARDS
Turn the piece back over. Fold small
end fl ap inwards to help secure the
nose.
9
FOLD THE DOTTED
LINES INWARDS
Fold the dotted lines inward at the
rear of the piece.
