LMAN0071-01-EN
Hazardous Location Series
07/29/20
Page 2
GENERAL WIRING DIAGRAM
•
CAUTION:
Turn off electrical power at fuse
or circuit breaker box before wiring fixture
to the power supply.
Connec�ng panels to AC source supply:
All units must be individually connected
to the AC supply.
Black = Line
White = Neutral
Green = Ground
INSTALLATION & OPERATION
Electrical Connec�on:
1. Loosen the ten M6 hexagon bolts with spring washers and nuts of Tank Cover with torque value 7 N-m.
2. The thread of entry hole of Tank is 3/4” NPT. A�ach the Tank to suitable conduit.
3. Inset the wire from outside through the conduit and the entry hole of Tank, then connect to Terminal Block.
4. Introduce the wires of branch circuit as following:
Black wiring connects to Line
White wiring connects to Neutral
Green wiring connects to Ground
5. Re-a�ach the Tank Cover and �ghten it by ten M6 hexagon bolts
with spring washers and nuts with torque value 7 N-m.
6. Check the �ghtness of conduit and Tank Cover.
Wall/Ceiling/Floor Moun�ng Bracket:
7. The moun�ng bracket is for the use
of wall/ceiling/floor moun�ng.
8. Posi�on the moun�ng bracket and
fix it by means of two M6 and two
M8 hexagon bolts with spring lock
washers.
9. Secure the wall/ceiling/floor moun�ng
bracket to the structure by using
screws. (not provided).
FIGURE 1
10. The luminaire can be adjusted facing
down 90º from ver�cal = Lens
horizontal facing down on ceiling
posi�on.
FIGURE 2
11. The luminaire can be adjusted up and
down by 45º on wall/floor posi�on only.
FIGURE 3
Figure 1
Figure 2
Figure 3
Wall Type
Floor Type
Ceiling Type
LED Driver
BLACK (LINE)
GREEN (GROUND)
WHITE (NEUTRAL)
AC INPUT
( - ) ( + )
LEAN WIRES
TO LED LOAD
Terminal
Block
