Deceleration Programming:
1.
Ensure that the locomotive you wish to programme is the only one on the track.
2.
Press and hold the Function
for 1 second. The LCD display will flash “dE” (Deceleration).
3.
Input deceleration time by pressing the appropriate numerical key(s). The lower the numbers entered the
faster the deceleration.
The higher the number (maximum 99) the slower.
4.
Press “SELECT” to confirm.The LCD will flash the deceleration level once.The red LED will flash up to seven
times during which the decoder will be accepting the command. If the LED flashes eight times, it is advisable
to reprogramme the Decoder again.
5.
The LCD screen then changes to show the current locomotive address.
6.
Turn the Control Knob clockwise and the locomotive will gradually accelerate to the speed level that was
entered previously.
Turn the Control Knob anti-clockwise and the locomotive will decelerate at the speed level that was input.
Deceleration Control
Up to 99 acceleration and 99 deceleration levels can be programmed to each locomotive.
Acceleration Programming:
1.
Ensure that the locomotive you wish to programme is the only one on the track.
2.
Press and hold the “FUNCTION”
for 1 second.
The LCD display will flash “AC” (Acceleration).
3.
Input the acceleration time by pressing the appropriate numerical key(s).The lower the numbers entered the
faster the acceleration.The higher the number (maximum 99) the slower.
4.
Press “SELECT” to confirm.The LCD will flash the deceleration level once.The red LED will flash up to seven
times during which the decoder will be accepting the command. If the LED flashes eight times, it is advisable
to reprogramme the Decoder again.
5.
The LCD screen then changes to show the current locomotive address.
6.
Turn the Control Knob and the locomotive will gradually accelerate at the speed level that was entered.
Acceleration Control
For more information visit:
www.hornby.com
Please Note:
1 second per acceleration level (eg. an acceleration level of 10 equals 10 seconds approximately).
Important:
Should you wish your locomotives to have varying levels of acceleration/deceleration then you must
programme them all individually. However if you require all your locomotives to have the same level of
acceleration/deceleration you need not remove them from the track. In this instance programming one
locomotive with acceleration/deceleration will programme them all.
1.
Remove all locomotives from the track apart from the one to be programmed.
2.
Decide on an address (eg. No. 2).
3.
Press and hold the Select button for 2 seconds. The LCD display will flash “LA” (Locomotive Address).
4.
Press button
on the unit keypad. The LCD display will flash “2”.
5.
Press “SELECT” to confirm.The LCD will flash the deceleration level once.The red LED will flash up to seven
times during which the decoder will be accepting the command. If the LED flashes eight times, it is advisable
to reprogramme the Decoder again.
6.
The locomotive is now programmed as No. 02.
Repeat this procedure for programming additional locomotives up to No. 59.
2
Adding a Further Locomotive
Please Note:
Ensure that the track circuit is always clear of locomotives other than the one chosen for programming.
To add Acceleration and Deceleration see previous page.
8
9
Select Unit Additional Benefits
