For more information visit:
www.hornby.com
The
Select
unit can have stored in its memory 10 digitally controlled locomotives
any one time the
Select
can have running (providing the power is available) or on standby,10 locomotives.
This is more than
for an above average layout, however should an eleventh loco be “called up”, one of
the previous 10 locomotives will be removed from
Select’s
memory. The locomotive that is removed, will be
the locomotive that has the lowest current Speed address compared to the other 9.
Alternatively, if all 10 locomotives are stationary, the locomotive with the lowest address number will be removed.
Control Up to 10 Locomotives
The transformer included with the
Select
unit will probably provide enough power to allow for three locomotives
to be running at any one time, providing the models used are fitted with power efficient motors. Should more
power be needed the
Select
should provide enough power for an average layout.
If under special circumstances even more power is needed it may become necessary for a “Booster” unit to be
fitted.This will entail the track circuit to be broken up into
sections to which the Boosters
connected.
Power Boosters
18
19
R
How many locos can
the Select run?
e-setting the Select
To perform a reset:
1.
Press and hold the STOP
+
.The LCD display will display “C5” (Command Station).
2.
Press
The LCD will display “0”.
3.
Press
The red LED will flash 5 times to confirm the settings.The LCD will display “03”.
4.
The
Select
Select
.
Select
.
unit will now be restored to its factory settings.
How to switch OFF Analogue/DC locomotive Support
1.
Press and hold the “STOP”
+
for 1 second. The LCD display will display “C5”
(Command Station).
2.
Press “FUNCTION” to toggle between C5 (Control Station) and HC (Hand Controller) modes. Ensure C5
is shown.
3.
Press “SELECT” to select C5 mode. The LCD will flash twice and display “0”.
4.
Press “FUNCTION” to toggle between 0 (enable) and -0 (disable) to enable/disable analogue locomotive
modes.
5.
Press “SELECT” to confirm your choice.
The RED LED will ash 5 times to con rm the
set
t
i
ng
s
.
The LCD will display “03”.
unit is capable of being connected to a R8113 Hornby 4 amp Power Unit which
i.e.
isolated
are
Please contact your Hornby dealer or Customer Care for more information regarding the use of Boosters and
how to connect them to your layout.
RE-SETTING THE CONTROL UNIT DOES NOT REMOVE ADDRESSES FROM LOCOMOTIVES.
Re-setting the
Select
will remove all previously assigned addresses from the unit’s memory (with the
exception of No. 3). Groups created for Double Heading will also be cleared from the units memory.
