3
2
DCC
Ready
If your locomotive is not pre-fitted with
a decoder, please see Fig.6 for location
of DCC socket.
Fig.4
Fig.6
Body
Removal
1
3
3
Lubrication
1
Fig.1
Fig.5
IMPORTANT – Only apply small single drops of light machine oil to the places indicated in red in Fig.2. This is best achieved by making a simple oil ‘dropper’ as illustrated in Fig.1. Insert a straightened paper clip into a cork and use a bottle
cap as a container for the oil. A small drop of oil can then be picked up by the dropper and applied in exactly the right place. Immediately wipe off any excess oil, especially from the locomotive body. Only lubricate moving parts.
Apply one drop of oil to each of the valve gear and connecting rod
pivot points indicated in red in Fig.2, on both sides of the locomotive.
Fig.3
Apply one drop of oil to each of the axle bearings indicated in red in
Fig.3, on both sides of the locomotive.
Fig.2
Turn locomotive upside down and remove screw as shown in Fig.4.
Carefully turn locomotive the right way up. Ease the body away from
the chassis in the direction shown, until the location lugs at the front of
the chassis are clear of the body (Fig.5).
Please keep the screw safe for re-assembly.
