Good Cut
Bad Cut
Ensure each air line is fully seated over the
compression fitting before tightening the nut
down over it. If the line is not fully seated over
the barb, it can slip off the fitting even with the
nut in place. Hold the line in place and use a
wrench to tighten the compression ferrule down.
The compressor filter must be changed out
every 2-3 months, otherwise the compressor
will start to
!
pull in dirt/dust and wear
prematurely. The filter
!
can be swapped out with
three easy steps, as
!
shown below.
Use a flathead screwdriver to pry
the filter housing apart. You can
insert the flat end of the
screwdriver into seam, where the
arrow is
Remove the old
filter element from
the housing. Insert
the new element
into the center so
that the white
portion of the filter
lines up with the
plastic tabs.
Replace the cover
back over the
housing, lining the
tabs up on the
sides of the cover.
Make sure the 5/16" lines are equal length!
