5
How to Program Your RFID Tags
Your RAPiD
®
Safe includes three (3) styles of RFID tags, including:
• 1 Wristband
• 1 Key Fob
• 2 Decals
*Additional styles can be purchased separately.
The RAPiD
®
Safe can store up to 5 tags.
To program these tags:
1. Open the RAPiD Safe with either the
key or a previously programmed RFID
tag or key code. (The vault does not
ship with pre-programmed RFID tags.
A RFID tag must be programmed to
work with this vault.)
2. Locate the red program button. Press
and release the button to begin
programming a RFID tag. The first
available program location will begin
to blink.
3.
Hold the RFID tag within 1"
of the
illuminated RFID reader area on the
vault door. If the programming was
successful, the vault should beep two times and the available slot should go from
blinking to solid red for approximately ten seconds.
NOTE:
If the user attempts to program a RFID tag that is already stored in the vault it
will beep three times and the RFID tag will not be programmed into the duplicate slot.
The RFID tag can only be programmed into one location.
4. Verify the RFID tag is programmed by holding the tag over the RFID reader with the door
open. The motor should cycle after each scan.
5. If the RFID tag is not programmed, the program function will time out after ten seconds
and the vault will return to normal operation. If multiple attempts to program a RFID tag
fails, please contact Hornady
®
at 800-338-3220.
6. One to five RFID tags can be programmed into the vault.
Program Button
