8
EN
Before the fi rst fl ights, or in the event of an
crash, make sure the fl ight control surfaces
are centered when the transmitter controls and
trims are neutral. The transmitter sub-trim must
be set to zero.
Adjust the linkages mechanically if the control
surfaces are not centered. Use of the transmitter
sub-trims may not correctly center the aircraft
control surfaces due to the mechanical limits of
linear servos.
Make the U-shape narrower to make the connector
shorter. Make the U-shape wider to make the
linkage longer.
Control Centering
Control Horn Settings
The table to the right shows the factory settings for
the control horns. Fly the aircraft at factory settings
before making changes.
After fl ying, you may choose to adjust the linkage
positions for the desired control response.
CAUTION:
When these are incorrectly
connected for the pilot’s skill level, unexpected
aircraft response to controls can result. This can
cause damage to the aircraft and personal injury.
Elevator Rudder
Optional Decals
Increase aircraft visibility by applying included
decals to the underside of one wing.
1. Ensure the wing is clean.
2. Lift a decal from a sheet and carefully apply it
to the aircraft.
3. Rub out from the center of the self-adhesive
decal to remove bubbles.
Option 1
Option 2
