Horizon Hobby Mini Convergence VTOL BNF Basic Instruction Manual Download Page 15

EN

15

Contact Information

FCC ID: BRWSPMR4648A

This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to part 15 of the FCC Rules.  These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and 
on, the user is encouraged to try to correct the interference by one or more of 
the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which 

the receiver is connected.

• Consult the dealer or and experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the 
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference 
that may cause undesired operation. 

NOTICE:

 Modifi cations to this product will void the user’s authority to operate 

this equipment.

This product contains a radio transmitter with wireless technology which has 
been tested and found to be compliant with the applicable regulations governing 
a radio transmitter in the 2.400GHz to 2.4835GHz frequency range.

Compliance Information for the European Union

FCC Information 

IC Information

IC ID: 6157A-SPMR4648A

This device complies with Industry Canada licence-exempt RSS standard(s). 
Operation is subject to the following two conditions: (1) this device may not 
cause interference, and (2) this device must accept any interference, including 
interference that may cause undesired operation of the device.

Instructions for disposal of WEEE by users in the European Union

This product must not be disposed of with other waste. Instead, it 
is the user’s responsibility to dispose of their waste equipment by 
handing it over to a designated collections point for the recycling 
of waste electrical and electronic equipment. The separate 
collection and recycling of your waste equipment at the time of 

disposal will help to conserve natural resources and ensure that it is recycled 
in a manner that protects human health and the environment. For more 
information about where you can drop off your waste equipment for recycling, 
please contact your local city offi ce, your household waste disposal service or 
where you purchased the product.

Mini Convergence BNF Basic (EFL9350)
EU Compliance Statement:

 Horizon Hobby, LLC hereby declares 

that this product is in compliance with the essential requirements 

and other relevant provisions of the RED and EMC Directive. 

Mini Convergence PNP (EFL9375)
EU Compliance Statement:

 Horizon Hobby, LLC hereby declares that this 

product is in compliance with the essential requirements and other relevant 
provisions of the EMC Directive. 

A copy of the EU Declaration of Conformity is available online at: http://www.horizonhobby.com/content/support-render-compliance.

Country of 

Purchase

Horizon Hobby

Contact Information

Address

United States of America

Horizon Service Center

(Repairs and Repair Requests) 

servicecenter.horizonhobby.com/

RequestForm/

1608 Interstate Drive

 

Champaign, Illinois, 61822 USA

Horizon Product Support

(Product Technical Assistance)

[email protected]

877-504-0233

Sales

[email protected]

800-338-4639

European Union

Horizon Technischer Service

[email protected]

Hanskampring 9 

D 22885 Barsbüttel, Germany

Sales: Horizon Hobby GmbH

+49 (0) 4121 2655 100

Summary of Contents for Mini Convergence VTOL BNF Basic



















Reviews: