STEP 2
10.
Mix 1/2 ounces (15mL) of 30-minute epoxy. Use an epoxy brush to
apply epoxy to one of the top/bottom plates. Apply epoxy to the top/
bottom plate.
11.
Place a second top/bottom plate in position. Repeat until the second
set of side plates and top/bottom plates have been positioned.
STEP 3
13.
Mix 1/2 ounces (15mL) of 30-minute epoxy. Apply epoxy to a single
square end plate.
14.
Place the square end plate in position. Repeat for the fi nal square
end plate.
12.
Use low-tack tape to hold the motor box together until the epoxy
cures. Use a paper towel and isopropyl alcohol to remove any
excess epoxy.
It is critical to remove all excess epoxy or the
remaining pieces will not fit into position.
15.
Use low-tack tape to hold the motor box together until the epoxy
cures. Use a paper towel and isopropyl alcohol to remove any excess
epoxy. Allow the epoxy to fully cure before proceeding.
Use medium grit sandpaper to sand the motor
box if necessary for a finished took.
19
EN
Tiger 30cc ARF
