EN
11
Receiver Wiring Diagram
Reference the following diagram for all wiring
connections to the receiver.
Part #
Description
EFL02205
LED Set: Ultrix 600mm
IC2 battery connector
Bottom View Of Airplane
Looking At The Receiver
Points to nose
of the aircraft
Optional wing lights
Left Elevon Servo
Update Port
Right Elevon Servo
Gyro Port
Problem
Possible Cause
Solution
Control surfaces not at neutral
position when transmitter
controls are at neutral
Control surfaces not mechanically centered
from factory
Center control surfaces mechanically by
adjusting the U-bends on control linkages
Aircraft was moved after the flight battery
was connected and before sensors initialized
Disconnect and reconnect the flight battery
while keeping the aircraft still for 5 seconds
Model flies inconsistently
from flight to flight
Trims are moved too far from neutral position Neutralize trims and mechanically adjust
linkages to center control surfaces
Controls oscillate in flight
(model rapidly jumps or moves)
Propeller is unbalanced,
causing excessive vibration
Remove propeller and motor. Check motor
shaft for straightness and replace prop if
damaged
Recommended Parts List
Optional Parts
AS3X Troubleshooting Guide
Part #
Description
SPMX8503S30
850mAh 3S Smart G2 30C; IC2
SPMXC1080
Smart S1100 AC Charger, 1x100W
SPMXCA320
Adapter: IC3 Batt / IC2 Dev 6
Part #
Description
A EFL02201
Replacement Airframe: Ultrix 600mm
B EFL02202
Vertical Fin Set: Ultrix 600mm
C EFL02203
Pushrod/Nosewheel: Ultrix 600mm
D EFL02204
Battery Hatch: Ultrix 600mm
E SPMA3255
RX/ESC Unit: Ultrix 600mm
F SPMSH2040LW 2.9g Linear Long Throw Servo
G SPMXAM2000
1206-3900Kv Motor: Ultrix 600mm
H EFLP9448
Prop Set (4): Ultrix 600mm
