23
E-flite DHC-2 Beaver ARF Assembly Manual
Note
:
Do not
place or secure the flap servo cover in
position before turning on the radio and checking the
operation of the flap. Doing so could damage the flap
control horn or quite possibly the flap servo. Check the
length of the linkage as follows BEFORE installing the
flap servo cover.
20. With the radio system on, move the control on the
radio to the "Up Flap" position and test fit the cover. If
the cover does not fit without binding the flap or flap
servo, adjust the length of the linkage or change the
end points at the radio system to eliminate any binding.
Repeat the process for "Down Flap" and check that the
full throw is adjusted as noted in the "Control Throw"
section of this manual.
21. Secure the flap servo cover to the wing using
four #2 x 3/8-inch sheet metal screws and a
#1 Phillips screwdriver.
22. Repeat Steps 15 through 21 to install the remaining
flap servo.
