EN
5
Model Assembly
B
Required Adhesives:
Cyanoacrylate-Adhesive (CA)
Horizontal Tail Installation
1. Slide the horizontal tail
(A
and
B)
into the slot in the rear of the fuselage.
Ensure the control horn faces down.
2. Secure each horizontal tail piece in place with a bead of CA.
3. Attach the pushrod to the elevator control horn using the included clevis
TIP:
Use needle-nose pliers or ball link pliers (RV01005) to remove or install a
link on a control horn
Landing Gear Installation
1. Install the landing gear assembly
(A)
into the pocket located at the bottom
of the fuselage as shown.
2. Secure the landing gear into place with the 3 included screws
(B)
(2 x 10mm self-tapping countersunk screws) as shown.
Disassemble in reverse order.
A
B
A