EN
HABU STS
8
A
Assemble the Aircraft
Nose Gear Installation
1. Connect the nose gear assembly servo connector to the nose gear servo
extension in the fuselage. When connecting the servo connectors match
the colored wires when inserting the male servo plug in the female. Orange
is the signal wire (S) red is positive (+) brown is negative (-).
2. Install the nose gear assembly (
A
) into the fuselage with the air vent
facing forward.
3. Secure the nose gear assembly using the eight 2 x 8mm screws (
C
).
Disassemble in reverse order.
Main Gear Installation
1. Position the aircraft so the bottom of the wing faces up.
2. Insert the main gear strut (
A
) into the gear plate hole located on the wing.
3. Carefully turn each strut in the gear plate until the horizontal section (
B
) of
the strut gently snaps into place.
Where needed, disassemble in reverse order.
2 X 8mm (8)
C
B
A
