a.
Screw on two TNC-type antennas, ensuring they are the correct frequency for your MobileMesh
radio. We do not recommend powering the MobileMesh without antennas attached.
3.
Power on the MobileMesh Radio:
a.
Momentarily depress the power switch on the side of the MobileMesh. The Battery and Status
LEDS should come on to let you know power is on.
4.
Connect to your host PC:
a.
Using H31-MM-CAB-RJ45 (Primary to RJ45) or H31-MM-CAB-USBA-MALE (Primary to USB-A),
connect the MobileMesh radio to your host PC. If you use H31-MM-CAB-USBA-MALE, your
system will enumerate a new Ethernet interface which you will set up in the step below. If you
use the RJ45 cable you will set up an existing Ethernet interface.
i.
The Primary connector has 14 pins and is labeled
PRI
ii.
To insert the connector, align the red dot and press down
iii.
To remove the connector, pull upward from the base of the connector. Do not pull on
the cable.
5.
Set up your network:
a.
Each radio comes from the factory with a 10.223.x.x address. This can be changed later by the
user, but should you ever need to reset the radio, it will default back to this address. The IP
address is provided on a label attached to each radio.
b.
To connect,
you need your host computer set up in the same subnet
.
Momentarily depress to turn the
MobileMesh handheld on. To turn off,
depress and hold for several seconds.