STRETCH FIRST
Before using your product, it is best to take a few minutes doing a few gentle stretching exercises.
Stretching prior to exercise will improve flexibility and reduce chances of exercise related injury. Ease
into each of these stretches with a slow gentle motion. Do not stretch to the point of pain. Make sure
not to bounce while doing these stretches.
WALL PUSH
Stand near a wall with the toes of one foot about 18" from the wall, and the other foot about 12"
behind the other foot. Lean forward, pushing against the wall with your palms. Keep your heels flat
and hold this position for a count of 15 seconds. Make sure that you do not bounce while stretching.
Alternate positions of your feet and repeat for a total of 8 repetitions.
STANDING QUADRICEPS STRETCH
Using a wall to provide balance, grasp your left ankle with your left hand and hold your foot against
the back of your thigh for a count of 15 seconds. Repeat with your right ankle and hand, and contin-
ue alternating for a total of 8 repetitions.
SEATED TOE TOUCH
Sit on the floor with your legs together and straight out in front of you. Do not lock your knees.
Extend your fingers towards your toes and hold for a count of 15 seconds. Make sure that you do not
bounce while stretching. Sit upright again. Repeat for a total of 8 repetitions.
28
7
TIPS
Developing A Fitness Program
Assembly
UNPACKING
Take caution when handling and transporting this unit. Never open box when it is on its side. Once
the banding straps have been removed, do not lift or transport this unit unless it is fully assembled
and in the upright folded position, with the lock latch secure. Unpack the unit where it will be used.
The enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled.
See owner’s guide for reference.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
INJURY!
Place your treadmill on a level flat surface. It is recommended that you place a protective
covering on your floor.
PARTS (see illustration on previous page)
• 1 Power Cord
• 1 Safety Key
• 2 Water Bottle Holders
• Left and right outer console mast boots
• 1 Hardware Pack (contents listed below)
TOOLS (included)
• 5mm Allen Wrench/Phillips Screw Driver
• Flat Wrench
• 8mm Allen Wrench or 6mm Allen Wrench
Note:
It is recommended that you apply grease to the threads of each bolt as you assemble your
treadmill, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and
bolts are in place and partially threaded in before completely tightening any ONE bolt.
HARDWARE
CONTACT HORIZON FITNESS CUSTOMER ASSISTANCE CENTER; TOLL FREE @ 1-800-244-4192
OR VISIT www.horizonfitness.com
A) Linkage Arm
45mm bolt
Quantity: 2
C) Console Assembly
Bracket
13mm nylon nut
Quantity: 2
B) Console Assembly
Bracket
40mm bolt
Quantity: 2
D) Console Mast Boot
16mm bolt
Quantity: 6
T25_T35 owner’s guidev1.0.qxd 6/17/2004 2:28 PM Page 8
