E-1 Error-message on the Upper Board
If there is belt movement upon start up of the treadmill, and an E-1
message occurs, follow the possible causes below
:
Possible cause:
.
•
Check all wire connections.
•
Verify that the sensor magnet is positioned in the front roller pulley.
•
Verify the distance between the RPM sensor wire and the front roller pulley
(2-4 mm). Reposition the RPM sensor closer to the pulley if possible.
•
Follow the auto-calibration instructions (reference auto-calibration in table of
contents).
•
Verify the signal of the RPM sensor by entering Diagnostics Mode. If there is
no signal present, check the continuity of the RPM sensor wire. If there is no
continuity, replace the sensor wire.
•
If the problem persists, replace the upper board.
If there is no belt movement upon start up of the treadmill, and an E-1
message occurs, follow the possible causes below
:
Possible cause:
•
Verify that all wire connections are properly attached.
•
Follow the auto-calibration instructions (reference auto-calibration in table of
contents).
•
Verify the diagnostic LED’s on the lower board. Reference diagnostic LED chart
for possible causes.
•
If problem persists, replace the lower board.
31
