horiba OCMA-500, Instruction Manual

Page: 90 / 141

Setting
70
Measurement Setting screen
If [Measurement Setting] is selected on the Setting Top screen, the Measurement Setting
screen opens.
The Measurement Setting screen shows the current measurement settings.
If an item is selected with the up/down button and the ENT button is pressed, a pop-up screen
appears to let you change the setting of the selected item.
Fig. 71 Measurement Setting screen
The setting items on the Measurement Setting screen are shown in the table below.
Table 23 Items on the Measurement Setting screen
Down button Selects the next item down. -
ESC button Returns to the Measurement Top screen. page 11
Button Function Page
Item Description
Setting range (unit)
or selections
Page
Extraction Time Sets the extraction time in the automatic measurement mode. 0 or 10 to 600 (sec) page 72
Separation Time
Sets the layer separation time in the automatic measurement
mode.
0 or 10 to 600 (sec) page 72
Fill Cell Time
Sets the cell filling time in the automatic measurement and
automatic calibration modes.
30 to 3600 (sec) page 73
Meas. Limit
Sets the maximum measurement time in measurement and
calibration.
If the measured value does not stabilize, measurement ends
when the set time (from the start of measurement or
calibration) elapses and the measured value at that time is
displayed.
60 to 3600 (sec) page 73
Drainage Time
Sets the drainage time in the automatic measurement and
automatic calibration modes.
30 to 3600 (sec) page 74
Number of Purge
Sets the numbers of purges in the automatic measurement
mode.
0 to 9 (time) page 74
Meas. Mode Sets the measurement mode.
AUTO, SEMI-AUTO,
MANUAL
page 75
Measurement Unit Sets the units of measured values.
mg/L, mg/kg, mg/g, mg/
PC
page 75
Solvent Vol.
Sets the solvent volume used as a coefficient when the
measured value is converted to mg/kg, mg/g, or mg/PC.
1.0 to 1000.0 (mL) page 76