horiba ABX MICROS ES60, User Manual

Page: 184 / 200

ABX Micros ES60 OT/CT
7–36 User Manual - RAB237AEN
5.4. Troubleshooting system operations
Tab.7-8 Troubleshooting system operations
Poor repeatability
Possible dirty apertures
Perform a concentrated cleaning (See 3.3.5.
Concentrated cleaning, page 7-9 ), rerun sample
Possible leakage from syringe
blocks
Check syringe blocks for leakage and contact
your local HORIBA ABX Technical Support
Representative
Possible dirty chamber
Perform a concentrated cleaning (See 3.3.5.
Concentrated cleaning, page 7-9 ), rerun sample
Incorrect sample mixing
Mix sample just before placing into the tube
holder for each sample (CT). Mix sample just
before pressing the manual sample bar for each
sample (OT).
Possible partial blockage in
sampling needle Remove and flush out sampling needle (See
3.7. Unblocking sampling needle, page 7-17 )
Possible sampling needle
bent Replace sampling needle (See 3.8. Replacing
sampling needle, page 7-19 )
Problem noted Possible cause Corrective action
No power to the unit
Unit is powered off and/or
power cord is disconnected
from power source
Power on unit and/or plug in power cord to
power source
Possible blown power fuses
Contact your local HORIBA ABX Technical
Support Representative for assistance
No display on LCD
screen Possible disconnection of
cable to display
Contact your local HORIBA ABX Technical
Support Representative for instructions on re-
connection of cable
Motor errors on any
motor
Possible motor failure
Check motor operation (See 3.3.7. Mechanics,
page 7-10 )
Possible disconnected cable
to motor on main board
Remove main cover of the unit, check all
connectors, contact your local HORIBA ABX
Technical Support Representative for assistance
Problem noted Possible cause Corrective action