Horiba Scientific LAQUAact D-72G, Instruction Manual

Page: 34 / 94

Preparation
14
Tip
To change to the setting again, press the key to return to the "DATE" (date and time
setting) screen. The settings on screen before the key is pressed are not saved.
●
Connecting an electrode
To perform measurement, you must use the appropriate electrode for measurement
parameters. Recommended electrodes for each measured sample are listed in our
product catalog and on our website. Refer to them when preparing electrodes. Use the
following procedure to correctly connect the electrode to the instrument.
1. Insert the electrode connector by
fitting its groove with the
connector socket pin of the
instrument.
2. Turn the electrode connector
clockwise by following the
groove.
3. Put the connector cover on the
connector.
4. Insert the temperature connector
into the jack socket on the
instrument (only when using a
combination electrode equipped
with a temperature sensor).
Preparation for measurement is complete.
For details of the measurement operation, refer to the following pages.
Electrode connector
Temperature connector