Revision -
8 of 18
SECTION 4 – Installation
1.
Remove the factory bolts from the safety nets as indicated in Figure 2. The bolts
will not be reused, but the remaining hardware will be used.
Figure 2: Remove the factory safety net bolts.
2.
Place the provided loop clamps in the approximate mounting location on the front
roll bar. The
Audio Mini
brackets will rest on the loop clamps and be tightened in
the following steps. See Figure 3.
Figure 3: Approximate locations of the loop clamps.
3.
Using the supplied M6 x 1.0 x 30mm bolt and spacer, mount the bracket as shown
in Figure 4 still utilizing the factory safety net mount. Loosely tighten the bolts to
allow for adjustment of the
Audio Mini
placement.
Note: Driver side bracket
shown. (Passenger side similar)
Figure 4: Mounting locations of Audio Mini brackets.
