A
CCESSORIES
10 / 34
GPS General System Information - V01.03
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
2.2.3 Cable Installation
When laying the cable special attention must be paid to the following points:
•
The coaxial connectors should not be damaged or soiled. The connections should
be protected with plastic foil.
•
The bending radius of the cable must not be less than 50 mm.
•
No section of the cable should be squeezed nor should the insulation coating be
damaged
The cable is fed through the antenna base and connected to the antenna via a coaxial
connector. To lay the cables this can be disconnected. To do this the Allan screws on the
antenna base are removed and the dish is lifted off.
The cable must not be installed in the vicinity of other HF-, control or power
cables.
The emitted radio interference from these cables may interfere with GPS reception because
of the extremely low reception power.