Hope Electronics Technology
Manual
Edition
V2.0
13
1.4 Measurement steps
The measurement process is shown as below:
Measurement
preparation
1. Install the neck strap
2.Check the remaining batteries of the instrument
3. Connect the test lead
4. Turning the Power ON/OFF
5. Set the clock
Setting the
Measurement range
1. Set resistance range
2. Set voltage range
Zero Adjustment
Performing zero adjustment is according to the zero ajusting method
required by specified test leads
Start of the test
1. Connect the test leads to the battery
2. Read the measurement values
3. To retain measurement values
4. To store measurement values
End of the test
1.Disconnect the test lead and turn off the power
2. By using the USB cable included with the instrument you can send the
stored data to a computer.(data transmission software needs to be
installed).
