Installation Instructions
UM15H User Manual, 99142, July 2017
9
Power Connection
The HIS-UM15 is available with either AC or DC power input.
AC power input models are powered by 100 to 240 VAC, 1�0/0�5 A, 60/50 Hz� Loosen the
retaining clip for the power cable on the rear of the monitor. Connect the AC power cable to the
power input port on the monitor then retighten the retaining clip. Connect the other end into a
nearby outlet�
HAZ
LOC
NOTE:
If this step is not performed, the product will not comply with Class I,
II, III, Division 2 Hazardous Location requirements.
DC power input models are powered by 9�6 to 36�6 VDC, 2�5 to 0�65 A, Class 2 or SELV/LPS�
Install Touch Screen Driver
Applies to touch screen monitors only� Instructions below apply to Windows systems� Both Serial
and USB ports are present on all touch screen monitors, but only one should be used to connect
the touch screen interface to the monitor�
All touch screen monitors are shipped with a CD-ROM that contains documentation and drivers
for all major operating systems. To be sure that you have the most current information, please
check the following Internet address:
http://www�HopeIndustrial�com/Touchscreen_Drivers�htm
IMPORTANT!
If you will be using a USB connection,
install the touch screen driver first,
and then
connect the USB cable. If you will be using a Serial connection,
connect the Serial
cable first,
and then install the touch screen driver�
USB Connection
1�
Select the appropriate driver for your operating system.
a�
If downloading from the web address listed above, select the appropriate
driver for your operating system.