Push plug on power nozzle cord
completely into receptacle under-
neath hand grip.
Always disconnect cleaner from
electrical outlet before attaching
or removing power nozzle plug.
1-7
To attach the hose to the extension
wands, push latch (F) on the hand
grip to the unlock symbol.
Push the hand grip (G) down onto
wand so that the button projection (H)
fits into the slot. Push the latch to the
lock symbol to secure wand.
Attach second wand to the first.
Position cord into cord clips (E) on
wands, placing excess cord between
nozzle and bottom cord clip (located
on wand storage clip).
E
G
H
1-5
1-6
F
4
Connect hose, wands and nozzle
1-2
1-3
A
nozzle cord to canister cleaner.
23. Carrying handle
This cleaner is intended for house-
hold use.
This cleaner was inspected and pack-
aged carefully before being shipped
from the factory. If you should hap-
pen to need
assistance during as-
sembly or operation,
Visit us online at hoover.com to find
the service outlet nearest you (click
on the “Service” button) OR
Call 1-800-944-9200 for an auto-
mated referral of authorized service
outlet locations (U.S. only) OR Call
1-330-499-9499 to speak with a rep-
resentative in the Hoover Consumer
Response Center.
Connect hose
With hose toward front of cleaner,
push hose connector into opening in
bag lid.
When hose is attached properly,
hose cord plug will reach to recep-
tacle on cleaner.
Insert plug as deeply into the re-
ceptacle as possible. Latch (A) will
automatically fasten. Cleaner will not
operate unless plug is inserted into
receptacle.
To disconnect hose, first remove
hose cord plug from receptacle while
pulling out on latch. Then, depress
buttons (shown in Fig.1-2 by arrows)
on hose connector and pull up.
B
Note: The flexible hose contains
electrical wires for connection to
the power nozzle and should not
be used if damaged. The wires
should not be seen through the
outer skin.
Attach nozzle and wands
The wand with the storage clip con-
nects to the power nozzle.
Attach it to power nozzle by fitting
button projection (B) on nozzle con-
nector (C) into opening near end of
wand. Be sure nozzle is locked in
place.
To release, press down on center of
latch (D) and remove nozzle.
1-4
C
D
