Pull bracket toward bottom of handle
slightly to make sure bracket is
locked in place.
Make sure hole in bracket aligns
with hole in handle.
With
switch to the front,
place assembled handle down onto
extension on cleaner base.
Rock handle side to side while
pushing down firmly. Extra pushing
effort may be required.
Push
bolt
into hole (N) on lower
front
of handle.
If bolt will not go through hole
easily, check the following:
l
the bracket is properly
positioned (Fig. 1-9)
l
the handle is pushed down
completely (Fig. l-l 0)
Place
nut
in recessed area (0) at
back of handle.
Hold nut in place
while tightening bolt securely with a
screw driver.
Only one nut is needed on this
model. The extra nut is not required
but has been provided for your
convenience.
Step 4 Attach bag compartment
Pull bag door latch forward and
remove door. Set bag door aside.
Slide large tab (P) on bottom of bag
housing into slot between the brack-
et (Q) and the lower handle.
Note round opening and hooks (R)
on back of bag compartment.
Place opening over dirt tube (S) and
align hooks with slots in handle.
Push very firmly at
to snap
hooks into handle.
Pull on bag compartment to make
sure it is completely snapped to
handle.
Continued
