Hoover T 120 E, User Instructions

Page: 6 / 17

EN RU EN RU
10 11
Connect one end of the water
inlet pipe to the electrovalve
(top back part of the machine)
and the other to a tap or a
permanently plumbed-in
3/4” threaded connection.
IMPORTANT:
DO NOT TURN THE TAP
ON.
(Mod. T 185 E/1 - T 205 E/1 -
T 225 /1)
To move the washing machine
easily, turn the lever to the right.
Once you have finished moving
the machine, return the lever to
its original position.
Position the washing machine
next to the wall. Hook the outlet
pipe to the edge of the bath tub,
paying attention that there are
no bends along the tube.
It is better to connect the outlet
tube to a fixed outlet of a
diameter greater than that of
the outlet pipe and at a height
of min. 50 cm. If necessary use
the rigid bend supplied.
A
B
C
•
•
•
•
•
Use the front feet to level
the machine
a) Turn the nut clockwise to
release the screw adjuster for
the foot.
b) Rotate the foot to raise or
lower it until it stands firmly on
the ground.
c) Lock the foot in position by
turning the nut anticlockwise
until it comes up against the
bottom of the machine.
Check that the appliance is
properly levelled. To do so, try
and move the washing
machine by pushing on two
diagonally opposite top
corners at the same time to
see if it rocks.
If you move your washing
machine from oplace to
another, level the feet again.
Important!
If your washing machine is not
properly levelled, it will not
work properly. There could be
a lot of noise and unusual
vibrations.
Ensure that the machine is
switched off.
Ensure that all controls are set
to “0” and that the lid is shut.
When you close the door you
will hear a “click” confirming
that it is properly closed.
Insert the plug.
Press the On/Off button. The
power on light will light up. If
this does not light up see the
faults search section of this
booklet.