Hoover SteamVac Widepath, User Manual

Page: 4 / 15

The assembled cleaner will look like this
drawing.
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
Remove clean solution tank (upper tank)
from deep cleaner.
Place nuts in recessed areas on back of
handle. Hold each nut in place while
tightening each bolt securely (from the
front of the handle) with a Phillips screw
driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
With hose hook (Al) and cord hook (A2) to
back of deep cleaner, push upper handle
down onto lower handle. Push
bolts into
holes on front of handle. bolts will not
go through hole easily handle is not
pushed completely down.
Replace clean solution tank (upper tank)
by positioning bottom first. Press on
tank handle to snap top of tank into
place.
4
Remove tool and taped screw from
holder.
Insert projections on holder into slots on
back of cleaner.
When handle sections are completely
together, squeeze trigger (C) and
depress Clean Button (D) on
upper handle.
You will hear a “snap” when the trig-
ger rod is in place.
Slide rack down into place. Insert screw
at (E) and tighten with a Phillips screw-
driver.