• The steam mop and accessories get very hot during use, always allow them to cool down before handling.
• Always unplug and switch off the steam mop when assembling.
• Always switch off the steam mop before emptying the water tank or changing the cleaning pads/accessories.
•
IMPORTANT: Please refer to floor manufacturer’s care recommendations before use and test the steam mop
on a discrete area of flooring to begin with.
• When using the steam mop, basic safety precautions should always be observed.
• Don’t aim the steam mop at people, animals, plants and electrical components such as interior of ovens or wires.
Never touch the steam burst or floor head from a short distance. (There is a risk of scalding)
• The steam mop is equipped with a thermostat and a thermal cut-out. If for any reason the steam mop overheats it
will switch off. If this happens turn off and unplug the steam mop, allow to cool for a least 2 to 4 hours and re-start.
Push On/Off switch to
turn machine on
To produce steam
squeeze the trigger in
short bursts. Don’t
hold the trigger
continuously to prevent
over wetting floors
Move the steam mop
slowly backwards and
forwards across the
floor paying particular
attention to high traffic
areas. Squeeze/release
trigger as required
Hold corner of pad
down with foot and lift
steam mop to
peel away
Using the steam mop
OPERATION
6
Place the microfibre
pad on the floor
white side facing
up. Place steam mop
onto pad making
sure the entire pad
covers the
floor head
To steam your floors
with detergent turn
the dial to ON and
without detergent
turn the dial to OFF
Plug into mains and
press the power
button to switch on.
The blue light will
illuminate to show
power on. The green
light will illuminate
to show the steam
mop is ready to use
Adjust the steam dial
to desired setting
To recline the steam
mop place foot on
floor head and pull
handle backwards
