Hoover SM156WDPA, User Manual

Page: 6 / 8

3
FEATURES
CHARGING
Charging & LED Indicator**
1. Connect the charger to an ac wall outlet.
2. Connect the plug from the charger to the jack to charging socket. [1] Be sure the red light is on to indicate charging.
3. Before using the product disconnect the charger from the appliance and the ac outlet.
For the cleaner with LED Display *. The charging LED indicator** will flash to advise that the product is charging. When the product
is fully charged, the icon will stop flashing and remain lit.
For the cleaner without LED Display *. The charging LED indicator** will illuminate red all the time to advise that the product is
charging. When the product is fully charged, the red led will remain on.
NOTE: Use only the charger supplied with your cleaner to recharge the unit.
IMPORTANT: Before first use, charge your cleaner for at least 24 hours. When charging the cleaner, the power switch must be off. It is
normal for the charger to become warm to the touch when charging. If the operating time reduces after repeated use, let the cleaner
run until it stops, then recharge for 24 hours and repeat this monthly for best results. Never charge the batteries in temperatures
above 37°C or below 0°C.
HOW TO USE
Push the switch to ‘ON’ position to begin cleaning and to turn off move the switch to the ‘OFF’ position. Empty and clean the unit
and filter after each use or when the debris or liquid reaches the maximum fill line.
A On/Off Switch
B LED Display*
C LED Charging Indicator**
D Removable Crevice Tool
E Suction Inlet
F Dust Cup
G Charger
H Squeegee Tool
I
Dust Cup Open Trigger
This cleaner is equipped with a LED display*. When the product is on, the display will report following information:
Battery Level Indicator *:
• 4 bars = 100% charge
• 3 bars = 75% charge
• 2 bars = 50% charge
• 1 bar = 25% charge
• 0 bar 5% charge
LED DISPLAY*
*certain models only ** May vary according to model
REMOvABLE CREvICE TOOL
Fit the crevice tool onto the dust cup to clean corners and hard to reach areas.
[3]
WET PICK-UP
Fit the squeegee tool onto the dust cup to assist in collecting liquids.
[4]
Do not fill beyond the Max Line.
IMPORTANT:
Always keep the cleaner vertical (nozzle end down) during and after collection of liquids, to prevent spillage or liquid
entering the motor. Always empty the liquid out of the Container immediately after use. Do not pick up solvent based solutions,
inflammable or combustible liquids. After picking up liquids, the Container, Deflector and Filter MUST be thoroughly dried and the
squeegee removed before picking up dry dirt.
ATTACHMENTS
GB