Hoover SJ60DA/1 User Manual Download Page 6

Page: 6 / 9

FEATURES

STORAGE/CHARGING

MOUNT CHARGING BASE

TOOLS REQUIRED: SCREWDRIVER AND DRILL
CHARGING/STORAGE BASE
Designed to sit in the charging base on a flat surface or mount vertically.

[1]

For tidy storage wrap excess cord on the back of the charging base and exit either side or bottom.

TO WALL MOUNT

1.  Place the Measure* on the mounting surface vertically. Mark the centres of the holes.
2.  Move the Measure* then drill 4.8mm holes.
3.  Fit wall plug.
4.  Insert the Rawlplugs into the holes, and adjust the screws height to ensure Charging Base is fixed firmly to the mounting surface.

UNIT STORAGE

1.  Hold the unit by the handle and push firmly down onto the charging base.
2.  Be sure that the red light is on to indicate charging.
3.  Other storage methods are hanging the unit up using the storage hook, or adjusting the Nozzle

[3]

to allow the unit to stand

upright.

[2]

CHARGING
NOTE:

Use only the Charging Base

/Adaptor

with your cleaner to recharge.

IMPORTANT:

BEFORE FIRST USE, CHARGE YOUR CLEANER FOR AT LEAST 24 HOURS.

When charging the Cleaner power switch must be Off.
Keep the charger plugged into Charging Socket at all times. It is normal for the charger to become warm to the touch when
charging.
If the operating time reduces after repeated use, let the cleaner run until it stops, then recharge for 24 hours and repeat this
monthly for best results.

IMPORTANT:

Never charge the batteries in temperatures above 37°C or below 0°C.

HOW TO USE

TO USE:

Remove cleaner from storage base, slide the power switch to the ON position. Empty and clean the unit and filter after

each use or when the unit becomes full.

A.  On/Off Switch
B.  Charging Indicator
C.  Dust Cup Release Button
D.  Crevice Tool
E.  Dust Cup
F. Nozzle

G. Storage Hook
H. Charging Base

I. Dusting Brush

J. Adaptor

K. Charging Socket
L. Measure

*certain models only

ATTACHMENTS

CREVICE TOOL

The crevice tool is used to clean corners and hard to reach areas and is stored on board the dust cup. To use, remove the crevice tool
from the dust cup

[3]

then fit the crevice tool onto the nozzle to clean corners and hard to reach areas.

[4]

DUSTING BRUSH*

The dusting brush is stored in the wall bracket. Fit the dusting brush onto the nozzle to clean keyboards and other delicate areas.

[5]

DUST CONTAINER & FILTER: REMOVAL and REPLACEMENT

IMPORTANT:

FOR BEST RESULTS CLEAN THE FILTER AFTER EACH USE

Electrical requirements

This HOOVER appliance is supplied with a double insulated battery charger which is only suitable for insertion in a 230V (UK 240V)
socket outlet. Ensure that the Charging rating label matches your voltage supply.