GETTING STARTED
ASSEMBLY
FULLY ASSEMBLE PRODUCT PRIOR TO USE.
1
Insert the handle into the base.
2
Align the groove on the backside of the clean
water tank with the handle and drop straight
down.
OPERATION
CAUTION:
DO NOT USE THIS
EXTRACTOR ON HARD FLOORS. USING THIS
PRODUCT ON HARD FLOORS MAY SCRATCH OR
DAMAGE YOUR FLOOR.
CAUTION:
Use extra care when
cleaning on stairs. To avoid personal injury or
damage, and to prevent the cleaner from falling,
always place cleaner at bottom of stairs or on
floor. Do not place cleaner on stairs or furniture,
as it may result in injury or damage.
WARNING:
To reduce the risk of
personal injury, unplug before cleaning or
Emptying the dirt cup.
FILL THE CLEAN WATER TANK
1
Pull up to remove the Clean Water Tank.
2
Remove the cap from the Clean Water Tank. Add
warm water to fill line and replace cap.
FILL THE SOLUTION TANK
CLEANING FLUID
SEE THE HOOVER’S SOLUTION GUIDE insert or visit
Hoover.com/cleaning-solutions.
1
Remove the Solution Tank by pulling it up and out.
2
Fill the solution tank and replace cap.
3
Slide and push the Solution Tank back into place.
NOTE: Test for colorfastness in a small, hidden
area. Gently rub surface with a dampened white
cloth. Wait ten minutes and check for color
removal or bleed with a white paper towel.
NOTE: For the best results, vacuum carpet and
upholstery thoroughly with a HOOVER® vacuum
before use.
QUICK CLEAN MODE
NOTE: Feature included with select models only.
1
To engage Quick Clean Mode, turn knob
counterclockwise until engaged.
2
Return to Deep Clean mode by turning knob
clockwise.
HOW TO USE
1
Plug the cord into an electrical outlet.
2
On/Off
Recline
Turn unit ON/OFF with side pedal.
3
Recline unit with the middle pedal.
4
Squeeze trigger to apply water and cleaning
solution.
5
Slowly push forward with trigger pressed to wash,
then slowly pull backwards with trigger released
to dry.
NOTE: For Best Results, rinse the carpet after deep
cleaning with clean water only. This will remove
residual carpet cleaning solution from your
carpets. To rinse with clean water only, remove
the solution tank from the unit and then repeat
steps 4 and 5.
EMPTY THE RECOVERY TANK
NOTE: To maintain proper suction, empty Tank
when Red Bobber is visible.
1
Turn the cleaner off and unplug from electrical
outlet.
2
Grab the Recovery Water Tank handle and lift
up and outward to remove it. A second handle
is provided on the back of the Recovery tank for
carrying the tank.
3
Unlatch the tank lid and empty it. Rinse and allow
to air dry.
USING THE HOSE
CAUTION:
Always turn off appliance
before connecting or disconnecting hose.
CAUTION:
Not to be used for
grooming a pet.
1
Attach hose by opening the Hose Connection Port
on the nozzle.
2
Hold open the Hose Solution Port door. Plug the
Hose Solution Tube connector firmly into the Hose
Solution Port.
3
To drain the hose, run the unit and do not press
the spray button on the hose/tool end.
REMOVING THE HOSE
1
Press the button and firmly pull up to remove the
Hose Solution Tube from the Solution Port.
2
The Hose port Door is spring loaded to close
automatically. Ensure the Hose Port Door is fully
shut for the best performance.
NOTE: To ensure maximum performance and to
protect your carpet, be sure to place the handle in
the upright position while using the hose.