Hoover Ovens User Instructions Download Page 8

Meats:

It is better not to salt meats until after cooking as salt encourages
the meat to spatter fat. This will dirty the oven and make a lot of
smoke.
Joints of white meat, pork, veal, lamb and fish can be put into the
oven cold. The cooking time is longer than in a preheated oven,
but it cooks through to the centre better as the heat has more
time to penetrate the joint.

Correct preheating is the basis of successful red

meat cookery.

Grills:

• Before loading the grill:
Remove the meat from the refrigerator a few hours before grilling.
Lay it on several layers of kitchen paper: this improves seizing,
making it tastier and avoids it staying cold at the centre.
Add pepper and spices to the meat before grilling, but add any
salt after cooking. This way it will seize better and stay juicy.
Baste all the food to be cooked with a little oil. This is best done
with a wide flat basting brush. Then sprinkle with more pepper
and herbs (thyme, etc.).
Load the grill.
• During cooking:
Never pierce the food during cooking even when you turn it. This
lets the juice out and it becomes dry.

Baking:

Avoid using shiny tins, they reflect the heat and can spoil your
cakes. If your cakes brown too quickly, cover them with grease-
proof paper or aluminium foil. Caution: the correct way to use foil
is with the shiny side in towards the cake. If not the heat is
reflected by the shiny surface and does not penetrate the food.
Avoid opening the door during the first 20 to 25 minutes of cooking:
soufflés, brioches, sponge cakes, etc. will tend to fall. You can
check if cakes are done by pricking the centre with a knife blade
or metal knitting needle. If the blade comes out nice and dry, your
cake is ready and you can stop cooking. If the blade comes out
moist or with bits of cake attached, continue baking but slightly
lower the thermostat so that it is finished off without burning.

 KEEP WARM MODE / DEFROST MODE

The access for these two functions is direct.

• Keep Warm Mode : the top and bottom elements are used
intermittently with the fan circulating the hot air inside the oven.
Ideal for keeping dishes hot without oven cooking, suitable for
meringues and plate warming.

.... the temperature is pre-set to constant 60 degrees C
(no adjustment is available).

• Defrost mode : the top and bottom elements are used with the
fan circulating the hot air inside the oven. Wrap  the food to be
defrosted in aluminium foil, shiny side out.
 

.... the temperature is pre-set to constant 40 degrees C 
(no adjustment is available).

These two functions can be pre-programmed. To do this, turn the
programme selector knob to "Cooking time" or "End of cooking
time". The cooking time or the end of cooking time will start
flashing. Using the central button, adjust the time as you desire
and confirm. When you have done this, do not forget to turn the
programme selector knob back to      in order 

to confirm the

new programme.

For more details about programming, refer to the chapter entitled
PROGRAMMING.

23 GB

  PROGRAMMATION

DISPLAY SYMBOLS

THE TIMER:

The timer works independently of the oven and has no effect on
the heating elements. It is simply a reminder.

• Turn the knob to the Timer position. The Timer symbol will
appear. The digits 00:00 will appear on the display.
• The minutes will then flash, turn the central button to the required
number of minutes and confirm by pressing the same button.
• The hours will flash, turn the central button to the required
number of hours and confirm by pressing the same button.
• Turn the knob back to the      position.

When the time is up, the cooking time will disappear. An audible
signal will sound for 15 seconds and the Timer display will flash (to
stop it before the 15 seconds are up, just press the central button).

PROGRAMMING THE COOKING TIME:

various recipes are pre-programmed with a cooking time. In Manual
mode, Defrosting or Keep warm Mode can be pre-set, if required.

• Turn the knob to the Cooking time position. The Cooking time

symbol will appear. A pre-programmed cooking time for the various
recipes will appear, or 00:00 for other functions of the oven.

• With the minutes flashing, turn the central button to the  required

number of minutes and confirm by pressing the same 
button.
• With the hours flashing, turn the central button to the required
number of hours and confirm by pressing the same button.
• Turn the programme selector knob back to the STOP position
to confirm the new cooking time.

When the time is up, the cooking time will disappear from the
display. An audible signal will sound for 15 seconds and the Cooking
time and STOP symbols will flash.

• Turn the programme selector knob back to STOP. If you do not
do this, the Cooking time and STOP symbols will continue  flashing.

PROGRAMMING THE END OF COOKING TIME:

various recipes are pre-programmed with a cooking time and
therefore with an end of cooking time. In Manual Mode, Defrosting
or Keep warm mode can be pre-set, if required.

• Turn the knob to the End of cooking position. The STOP symbol

will appear. A pre-programmed end of cooking time for the various
recipes will appear, or 00:00 for other oven functions or the time
of day will be shown.
• Turn the programme selector knob 

to confirm the end time

.

• The minutes will flash. Turn the central button to indicate the

required number of minutes, and confirm your choice by pressing
the same button.

• The hours will then flash. Turn the central button to indicate the

required number of hours, and confirm your choice by pressing
the same button.

NB :

 with a delayed start, the end of programme time will appear

on the display with the "Cooking time" and "STOP" symbols, and
only the function mode of the oven remains.
The oven automatically calculates the start time (end time minus
cooking time).

At the end of the cycle the oven switches itself off automatically.
For 15 seconds, an audible signal lets you know that the cycle has
ended and the "Cooking time" and STOP symbols will flash.

• Turn the function selector knob to     . Unless you do this, the

symbols will continue flashing.

Programmation

control knob

Timer in operation

Cooking time programming

End of cooking time programming

Child safety device operational

Locking oven door

Summary of Contents for Ovens










Reviews: