97
THE WATERBLOCK SYSTEM
Fig. 1
A
The waterblock system has been designed to improve the safety of your appliance,
particularly when the machine is left unattended.
The waterblock system actually prevents flooding which might be caused by a
machine malfunction or as a result of a fracture on the pipes.
How does waterblock work
The sump located in the base of the appliance collects any possible water leakage
and operates a sensor which subsequently activates a valve placed under the water
tap and stops any water from the supply even with the tap fully opened. If the box
containing the electrical parts is damaged, remove the plug from the socket
immediately.
To ensure perfect operation of the safety system, box “A” with the hose, should be
connected to the tap as shown in figure “1”. The inlet hose should not be cut, as it
contains parts under load. If the hose is not long enough for correct connection, it
must be replaced with a longer one. The hose can be obtained from your Service
Agent.
This dishwasher is also equipped with an anti-overflow safety device which, if water
exceeds normal levels due to malfunctions, automatically blocks water flow and/or
drains excess quantities.
■
Delayed start cancellation is confirmed
when the selected programme LED
starts to blink and the selected programme
will displayed again (any selected
options will also be cancelled and the
corresponding LEDs will turn off).
■
At this point, a new program and option
button must be set to start a new
programme as indicated in the
"PROGRAMME SETTINGS"
section.
WARNING!
To ensure the correct operation of
the anti-overflow safety device, it is
recommended not to move or to tilt
the dishwasher during operation.
If it is necessary to move or to tilt
the dishwasher, first make sure the
washing cycle is finished and that
no water is left in the tank.
96
AUTOMATIC FAULT SIGNALS
Turn off the dishwasher, open the
inlet hose and reset the cycle.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Contact Customer Service.
Contact Customer Service.
Clean the filter plate.
If the problem persists, contact
Customer Service.
Re-set the required programme.
FAULTS
CAUSE
SOLUTION
E2
appears on the display and
the buzzer sounds.
E3
appears on the display and
the buzzer sounds.
E4
appears on the display and
the buzzer sounds.
E5
appears on the display and
the buzzer sounds.
E6
appear on the display and
the buzzer sounds.
E8
or
Ei
appear on the display
and the buzzer sounds.
"BLACKOUT"
appears on the
display.
No water (Inlet hose closed).
The machine cannot drain water.
Water leak
Electronic temperature control fault.
Electronic control fault.
The water-heating element is not
working correctly or the filter plate is
clogged.
The power failure occurs during
countdown for "PROGRAMME
START" or for "PROGRAMME END".
The dishwasher is able to signal a series of faults in the display.
